Flip through our historyWhat is the recurring cost of batteries and lead time for delivery)
Usually the batteries are in stock. Therefore they can be sent in a short time. The cost depends on the data logger model.
Related products
- L-Disk
- PressureDisk
- MicroW L
- SterilDisk
- L-Disk HT
- P-Micro
- PressureDisk 05
- PressureDisk V
- RHTemp125 L
- RHTemp125 XL
- RHTemp80 L
- RHTemp80 XL
- S-Disk J
- SterilDisk Probe
- SterilDisk Flexible
- SterilDisk Probe 10
- S-Micro
- S-Micro with thread
- S-Micro L
- S-Micro XL
- S-MicroW L Bendable Rigid Probe
- MicroW L Flexible
- MicroW L Ultra Freeze
- MicroW XL
- S-MicroW XL Bendable Rigid Probe
- MicroW XL Flexible
- MicroW XL Ultra Freeze
- S-Micro XL / MicroW XL heat protection 2
More faqs
- Tecnosoft
- Monitoring Solutions
- Technical Assistance
- Tecnosoft service and support website
-
Generic Technical
- At what temperature / humidity / pressure can I use my logger?
- Can I use my logger in the X environment (X = particular environment, generally different from those in which the device is typically used)?
- Can I use my logger under water / other liquid?
- Does the sensor measure on the tip of the probe or on the whole length (for logger with probe)?
- Where is the temperature measured (for loggers without tip / probe: SterilDisk)?
- Where is the temperature measured (for loggers without tip / probe: TempStick)?
- Which is the response time (T90) of the sensor?
- What Response Time Is
-
Software Generic
- Where can I find the software to download for my device?
- Message “PC protected by Windows” when launching TecnoUtility
- Software is downloaded but installation does not complete
- Installation does not start
- Software is already installed but TecnoUtility does not recognize it
- The software requires me to register
- Software is installed but I need a code to run it
- I cannot send the email/don’t receive the email
- Does registering a software have a fee?
- On how many PCs can I install the software?
- I have registered the software but it requires a key that I don’t have
- Is it necessary to update the software?
- I purchased a new logger, why do I need to update the software?
- Where is the manual of the software?
- Which software allows the calculation of lethality / F0?
- How can I set F0?
- What formula do you use for F0?
-
Lead Time and Shipments
- Where should I send the devices under maintenance?
- When will I receive the logger under maintenance back here?
- When are you going to ship my order?
- What are the lead times for maintenance?
- How soon do I have to send / bring the instrument to have it on time?
- Do you collect and return the loggers, or do we need / can use our courier?
- Can I come at Tecnosoft to collect my devices?
- Generic Troubleshooting
-
Certificates
- I lost my logger's calibration certificate!
- What type of certificate is provided with the data loggers?
- Are all logger provided with a certificate?
- How can I obtain a certificate?
- If I request a calibration, do I also receive a certificate?
- Where can I find calibration certificates for loggers?
- What ISO / Accredia traceable certificate mean?
- Can I have a LAT (primary) certificate?
- What does it mean that the loggers are recalibrated?
- Can I get the certificate on desired points?
- On how many points is the calibration done / the logger checked?
- How often should I recalibrate the logger?
- Where can I find the reference instrument certificate?
- Where should I ship the devices? To whom should I address them?
- Is it also verified when I send a logger for calibration?
-
Calibration / Readings errors
- What does it mean that accuracy is valid in the calibration range?
- The logger / sensor has an operating temperature range but the accuracy is valid in another range: why?
- Logger’s measuring not correctly
- The logger measures a different value from that indicated by the display of the cell / thermometer / other logger / other
- Loggers are not reading the same values
- I tried the loggers together and they are sensing different values
- Can I recalibrate the loggers by myself?
- The sensor and / or the circuit have been replaced on my logger: is recalibration mandatory?
- The battery has been replaced on my logger: is recalibration mandatory?
- How should I perform recalibration correctly?
- How and who will carry out the annual calibration and what is the cost of it?
-
Pressure Monitoring
- Does PressureDisk measures relative pressure?
- What do relative pressure and absolute pressure mean?
- Pressure data recorded by PressureDisk are different from the ones of my autoclave!
- Why does a hot data logger read a pressure different from one at room temperature?
- Is it normal for two loggers at different temperatures to read two different pressures?
-
High Temperature Data Loggers
- Logger does not connect
- What are the spare parts and recurring costs?
- The sensor / circuit (or both) has been replaced on my logger. Why do I need to recalibrate the logger?
- S-MicroW and PressureDisk models are suitable for Thermal Validation of Autoclave?
- What is the recurring cost of batteries and lead time for delivery)
- In case of damage, can the loggers be repaired? Who will carry out and where will the service be done? What is the lead time?
- PressureDisk Data Logger
- Pirani Vacuum Logger Data Logger
- Radio Systems
-
SPD software
- It doesn't connect
- Where data are saved?
- How do I open old missions?
- How do I calculate F0?
- Why the writing F0 is not printed when generating the report?
- What do the parameters for calculating lethality mean?
- I did not set the correct F0 / lethality profile before starting the logger: do I have to redo the test?
- What does it mean that there is a synchronization error?
-
TS Manager Software
- The logger does not connect
- What if I forget the password?
- USB protection key error message
- I am banned but I must log in urgently
- It gives me an error connecting to the database
- How to configure the TS Manager database (stand alone version)
- Can I delete a Mission?
- Can I create a Group with a Single Mission?
- Can I add to a Group Missions from different device models?
- How many Missions can I group together?
- Can I create a Group with temperature, pressure and humidity?
- Can I create a Group with two pressure curves?
- What is MKT?
- What is Lethality?
- What is the Vacuum Leak test?
- What is Overkilling?
- What does it mean the data are encrypted?
- I need to generate a backup but I don’t have the Administrator rights
- When I try to generate a new database a rights error occurs
- HumiPressureDisk Software
- USB Drivers
- Batteries
- All faqs